Shield Max Bedwetting Alarm Starter Kit

The Strong HoldTM clip sensor is made of plastic and is designed to clip outside the child’s underwear. It This sensor grips the underwear tightly at night and will not come off. It is recommended for children and deep sleepers.
The patented IntelliFlex sensor used in the Chummie Alarms are made of silicone. These sensors have larger urine detection area and are taped to the outside of the underwear. Silicone sensors are recommended for children, teens and deep sleepers.

Shield alarms come with 3 alarm settings; sound only, vibration only and a combination of sound and vibration. For discreet operation, select the vibrate only option. On detecting urine, the Shield alarm will only vibrate to wake up your child and no one near them will know that the alarm has gone off

Yes! Many parents prefer to use a diaper when using the Shield Max Bedwetting Alarm to prevent sheets from getting soiled and wet. Simply attach the sensor to the outside of your child’s undergarment as shown below and wear the diaper on top.

Single tone alarms may lead to auditory accommodation – Child getting used to any one sound. The Shiemd Max Bedwetting Alarm comes with 8 unique alerts. Each time a bedwetting accident is detected, the alarm automatically changes to the next tone. This way, your child will be played a new tone the next time bedwetting is detected.

To clean the Strong Hold sensor, lift the lever up to release the underwear and open the sensor. Now, with the sensor open, gently rinse under warm tap water with liquid soap. Rinse thoroughly to ensure there is no soap on the sensor. Now, shake the sensor to remove excess water. To dry completely, insert a dry cotton towel or napkin and wipe dry.

You can purchase additional Strong Hold sensors here . You can contact us at 1-877-834-4107 if you prefer to order over the phone.

Yes, the Comfy-Armband is washable. Since it is made of Neoprene and Silicone, cleaning is easy. Remove the alarm unit from the Comfy-Armband and place the armband in warm water. Add a little bit of liquid soap and let it sit for 10-15 minutes. Then remove and rinse under warm tap water. Finally let the armband air dry. If you rather use a washing machine and dryer, first open the armband and place in the washer under warm and gentle wash cycle. Dry on low heat setting. Do not wring or iron the armband.

The Comfy-Armband is designed to fit children with biceps 9″ in diameter. This is normal for most children 13 and under. Since the armband is attachable, it is easy to increase or decrease the length.

Under normal use, the armband will easily last the duration of the treatment. In most cases, even a few years.